Renesas RL78 Series User Manual page 456

RL78/G1D
(Essential)
(Selective)
(Selective)
(Selective)
(Selective)
(Selective)
(Selective)
(Selective)
(Essential)
(Essential)
(Essential)
(Essential)
(Essential)
(Remark is listed on the next page.)
R01UH0515EJ0120 Rev.1.20
Dec 16, 2016
Figure 13-51. Procedure for Resuming Slave Transmission
Starting setting for resumption
Completing master
preparations?
Yes
Port manipulation
Changing setting of the SPSm register
Changing setting of the SDRmn register
Changing setting of the SMRmn register
Changing setting of the SCRmn register
Clearing error flag
Changing setting of the SOEm register
Changing setting of the SOm register
Changing setting of the SOEm register
Port manipulation
Writing to the SSm register
Starting communication
Completing resumption setting
CHAPTER 13 SERIAL ARRAY UNIT
No Wait until stop the communication target
(master)
Disable data output of the target channel
by setting a port register and a port
mode register.
Re-set the register to change the operation
clock setting.
Re-set the register to change the transfer
baud rate setting (setting the transfer clock
by dividing the operation clock (f
Re-set the register to change serial
mode register mn (SMRmn) setting.
Re-set the register to change serial
communication operation setting register
mn (SCRmn) setting.
If the OVF flag remain set, clear this
using serial flag clear trigger register mn
(SIRmn).
Set the SOEmn bit to 0 to stop output
from the target channel.
Set the initial output level of the serial
data (SOmn).
Set the SOEmn bit to 1 and enable
output from the target channel.
Enable data output of the target channel
by setting a port register and a port mode
register.
Set the SSmn bit of the target channel to 1
(SEmn = 1: to enable operation).
Sets transmit data to the SIOp register (bits
7 to 0 of the SDRmn register) and wait for a
clock from the master.
)).
MCK
435