Renesas RL78 Series User Manual page 375

RL78/G1D
12.7.3 Setting up hardware trigger wait mode
Start of setup
PER0 register setting
ADPC and PMC register settings
PM register setting
● ADM0 register setting
● ADM1 register setting
● ADM2 register setting
● ADUL/ADLL register settings
● ADS register setting
(The order of the settings is
irrelevant.)
Reference voltage stabilization
wait time count A
ADCE bit setting
Hardware trigger generation
Stabilization wait time for A/D
power supply
Start of A/D conversion
The A/D conversion operations are performed.
End of A/D conversion
Storage of conversion results in
the ADCR and ADCRH registers
Note Depending on the settings of the ADRCK bit and ADUL/ADLL registers, there is a possibility of no interrupt
signal being generated. In this case, the results are not stored in the ADCR and ADCRH registers.
R01UH0515EJ0120 Rev.1.20
Dec 16, 2016
Figure 12-31. Setting up Hardware Trigger Wait Mode
The ADCEN bit of the PER0 register is set (1), and supplying the clock starts.
The ports are set to analog input.
ANI0 to ANI3 pins: Set using the ADPC register.
ANI16 to ANI19 pins: Set using the PMC register.
The ports are set to the input mode.
● ADM0 register
FR2 to FR0, LV1, and LV0 bits: These are used to specify the A/D conversion time.
ADMD bit: Select mode/scan mode
● ADM1 register
ADTMD1 and ADTMD0 bits: These are used to specify the hardware trigger wait mode.
ADSCM bit: Sequential conversion mode/one-shot conversion mode
ADTRS1 and ADTRS0 bits: These are used to select the hardware trigger signal.
● ADM2 register
ADREFP1, ADREFP0, and ADREFM bits: These are used to select the reference
ADRCK bit: This is used to select the range for the A/D conversion result comparison
value generated by the interrupt signal from AREA1, AREA3, and AREA2.
AWC bit: This is used to set up the SNOOZE mode function.
ADTYP bit: 8-bit/10-bit resolution
● ADUL/ADLL registers
These are used to specify the upper limit and lower limit of A/D conversion result
comparison values.
● ADS register
ADS4 to ADS0 bits: These are used to select the analog input channels.
The reference voltage stabilization wait time indicated by A below may be required
if the values of the ADREFP1 and ADREFP0 bits are changed.
If the values of ADREFP1 and ADREFP0 are changed to 1 and 0, respectively: A = 5
A wait is not required if the values of ADREFP1 and ADREFP0 are changed to 0 and 0 or 0 and 1,
respectively.
The ADCE bit of the ADM0 register is set (1), and the system enters the A/D conversion
standby status.
The system automatically counts up the stabilization wait time for A/D power supply.
After counting up the reference voltage
The A/D conversion end interrupt (INTAD) is generated.
The conversion results are stored in the ADCR and ADCRH registers.
CHAPTER 12 A/D CONVERTER
voltage.
stabilization wait time ends, A/D conversion starts.
Note
s
354