Renesas RL78 Series User Manual page 797

RL78/G1D
26.5 Processing Time for Each Command When PG-FP5 Is in Use (Reference Value)
The following shows the processing time for each command (reference value) when PG-FP5 is used as a dedicated
flash memory programmer.
Table 26-10. Processing Time for Each Command When PG-FP5 Is in Use (Reference Value)
PG-FP5 Command
Erasing
Writing
Verification
Writing after erasing
Remark The command processing times (reference values) shown in the table are typical values under the
following conditions.
Port: TOOL0 (single-line UART)
Speed: 1,000,000 bps
Mode: Full speed mode (flash operation mode: HS (high speed main) mode)
R01UH0515EJ0120 Rev.1.20
Dec 16, 2016
Code Flash
128 Kbytes 192 Kbytes
2 s 2 s
3.5 s 5 s
3.5 s 4.5 s
4.5 s 6.5 s
CHAPTER 26 FLASH MEMORY
256 Kbytes
2.5 s
6 s
5.5 s
8 s
776