Diagnostics & Troubleshooting; Led Status Displays For Device Status - Lenze E84AVSC Operating Instructions Manual

7 Diagnostics & troubleshooting
7.1

LED status displays for device status

DRV-RDY DRV-ERR Description
OFF
OFF
OFF
OFF
Legend
The symbols used for indicating the LED states have the following meaning:
LED is flashing once approx. every 3 seconds (slow flash)
LED is flashing once approx. every 1.25 seconds (flash)
LED is flashing twice approx. every 1.25 seconds (double flash)
LED is blinking every second
LED is permanently on
from Firmware V06.00 - DMS 1.1 EN - 11/2011
The control of the two LEDs "DRV-RDY" and "DRV-ERR" in the lower
part on the front of the controller depends on the device status.
For the meaning please refer to the following table:
OFF OFF or initialisation active
OFF Safe torque off is active
OFF Device is ready to start
OFF Device is switched on
OFF Motor data identification/operation
The controller is ready to switch on, switched on or the operation is
enabled and a warning is indicated.
Fault active, quick stop
Trouble is active
Fault is active
System fault is active
L
8400 StateLine C | Operating instructions
Diagnostics & troubleshooting
LED status displays for device status
Device status
(Display in C00137)
Init
SafeTorqueOff
ReadyToSwitchOn
SwitchedOn
OperationEnabled
TroubleQSP
Trouble
Fault
SystemFault
45