Network Interface Specifications; Ethernet 10/100/1000Base-T - Alaxala AX3800S Hardware Instruction Manual

3.2 Network interface specifications

3.2.1 Ethernet 10/100/1000BASE-T

(1) Mode setting on the port
Any of the following modes can be specified for the Ethernet 10/100/1000BASE-T port.
The factory default setting is auto-negotiation.

Auto negotiation (default)

100BASE-TX full duplex (fixed)

100BASE-TX half duplex (fixed)

10BASE-T full duplex (fixed)

10BASE-T half duplex (fixed)
The following modes and auto negotiation are applicable to the Ethernet
NOTE
10/100/1000BASE-T port:





NOTE
As for 1000BASE-T, the fixed settings and half-duplex communication are not
supported.
(2) Flow control functionality
This function is enabled when the connection is fixed to full duplex.
NOTE
This function is not supported in AX3830S series switches.
(3) Auto MDI/MDI-X functionality
This function is enabled when auto negotiation is specified.
In the fixed settings, MDI-X is always selected.
(4) PoE system
As for the pin assignment of the power supply unit to the AC (PoE) models, Alternative A
defined in IEEE802.3af is used. Power supplies to the power receiver devices conforming
to IEEE802.3af are supported.
For power supply pin assignments on the Switch, see Table 3-2 Power supply pin
assignment.
1000BASE-T full duplex
100BASE-TX full duplex
100BASE-TX half duplex
10BASE-T full duplex
10BASE-T half duplex
3. Preparation of Interface Cables and Terminals
127