Table of Contents
Advertisement
Service and Maintenance
Remote Configuration and Alternative Connection Options
Configuring ISDN System Telephones via the PBX (Internal)
3. Enter your user name and password.
4. Click OK (this text is depending on the browser used).
The configuration manager opens.
5. Make the desired changes.
Configuring ISDN System Telephones via the PBX (Internal)
Requirements:
• PBX with internal ISDN system telephones
• In the PBX configured configuration port for system telephones
– Using the configuration manager (page Administration > IP configuration)
• An Ethernet connection between the PC and the PBX
Note: Alternatively it is possible to use a USB connection on the PC to one
of the internal system telephones including the complete installation of the
drivers required for the device on the PC.
• Installed COMfortel Set configuration software version 3.0, or later
• Knowledge of the user, sub-admin or admin PIN
1. Start the COMfortel Set configuration software.
2. Open the menu Options > Interface....
3. In the Interface list field, select the IP network option, and then in the IP address
entry field, enter the IP address of the PBX and in the IP port (Default: 7002) entry
field, enter the configuration port for system telephones on the PBX.
Note: If using the USB connection, select the option USB or ISDN card
(CAPI 2.0), depending on the used driver.
4. Click OK.
5. Open the menu File > Open.
6. Click Telephone.
768
COMpact 5000/R - Firmware V6.6A - Installation, Operation and Configuration V05 03/2016
Advertisement
Table of Contents
