Configuring The Pbx Remotely Via An External S Port (Ppp External) - Auerswald COMpact 3000 analog Operating Manual

Service and Maintenance
Remote Configuration and Alternative Connection Options
Configuring the PBX Remotely via an External S
Configuring the PBX Remotely via an External S
Important: Before you can configure the PBX remotely via a dial-up
connection, the required configurations must first be made via an internal
network connection.
Requirements:
– External S port (only COMpact 3000 ISDN or COMpact ISDN module available as an option)
0
– Configured remote switching number
Note: If no remote switching number has been configured, the PBX must be
activated for remote configuration using a digit sequence on an internal
telephone. After this, the PBX is accessible over each associated MSN/DDI.
– Configured dealer access number
Note: If no dealer access number has been configured or the telephone
number transmitted does not correspond with the configured telephone
numbers, the PBX must be activated via an internal telephone using a digit
sequence for remote configuration.
– Configured local and remote IP addresses
– Knowledge of the sub-admin or admin access data
Note: The external PIN may also be used for the dial-up connection. The
user password can also be used to log in.
– An existing external ISDN connection between the PC and the PBX over an Auerswald USB
device (e.g., COMfortel 2500) or an ISDN PC controller including the complete installation of
the drivers required for the device on the PC
Note: For an Auerswald USB device, this refers to the USB, the CAPI-2.0
and CoNDIS-WAN drivers. To install the drivers, refer to the driver installation
and Internet access instructions (CAPI/TAPI) that came with the device.
– The dial-up connection configured on the computer
– Release the PBX immediately before remote configuration if no dealer access number has
been configured or the transmission of the configured numbers is not possible on the
computer being used.
538
Port (PPP External)
0
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020
Port (PPP External)
0