Link-Aggregation Mode - H3C MSR Series Command Reference Manual

Syntax
lacp system-priority system-priority
undo lacp system-priority
Default
The system LACP priority is 32768.
Views
System view
Default command level
2: System level
Parameters
system-priority: Specifies the LACP priority of the local system, in the range of 0 to 65535. The
smaller the value, the higher the system LACP priority.
Examples
# Set the system LACP priority to 64.
<Sysname> system-view
[Sysname] lacp system-priority 64

link-aggregation mode

Use link-aggregation mode dynamic to configure an aggregation group to operate in dynamic
aggregation mode.
Use undo link-aggregation mode to restore the default setting.
Syntax
link-aggregation mode dynamic
undo link-aggregation mode
Default
An aggregation group operates in static aggregation mode.
Views
Layer 2 aggregate interface view, Layer 3 aggregate interface view
Default command level
2: System level
Usage guidelines
The following matrix shows the command and hardware compatibility in Layer 2 aggregate interface
view:
Hardware
MSR800
MSR 900
MSR900-E
MSR 930
MSR 20-1X
Command compatibility
Yes
No
Yes
Yes
No
108