Show Fense Server [Op-Vaa] - Alaxala AX6700S Software Manual

8. Authentication VLANs [OP-VAA]

show fense server [OP-VAA]

Displays information set for an authentication VLAN, and the operating status of the current
VLANaccessAgent.
Syntax
show fense server [id
Input mode
User mode and administrator mode
Parameters
id <id no list>
Displays information about connection of the specified authentication server
(VLANaccessController).
[Specification using numeric values]
Specify a unique VAA ID.
[Specifying a range by using "
All VAA IDs in the range are specified.
Operation when this parameter is omitted:
Displays all information about configured connections.
detail
Displays the detailed connection information of the specified authentication server
(VLANaccessController).
<vlan id list>
Specifies multiple VLAN IDs which have been set as authenticated VLANs.
For details about how to specify <vlan id list>, see Specifiable values for parameters. Note
that the default VLAN (VLAN ID = 1) cannot be specified for this command.
Operation when this parameter is omitted:
Displays all information about configured VLANs.
Operation when all parameters are omitted:
Displays all information about configured VAA IDs and VLAN IDs.
Example
The following shows an example of displaying all configured VLANaccessAgent
information:
>show fense server
Date 2007/01/26 10:50:49 UTC
VAA NAME: switch01
VAA Sync Mode: Sync
Current Registered MAC:
Server Information:
ID:1
Server Address: 192.168.2.100
Target-VLAN Count:
ID:2
Server Address: 192.168.3.200
228
<id no list>
" or "
-
20
Status: enable
Retry Timer: 10
Alive Timer: 20
4
Status: enable
<vlan id list>
] [detail [
"]
,
Agent Status: CONNECTED
Retry Count: 25920
Agent Status: DISCONNECTED
]]
Port: 52153
Current Count:
Port: 52153
0