Set Mac-Authentication Mac-Address - Alaxala AX6700S Software Manual

7. MAC-based Authentication

set mac-authentication mac-address

Adds a MAC address for MAC-based authentication to the internal MAC-based authentication
DB. Specify the VLAN ID to which the user belongs. You can add a MAC address that has already
been registered if its VLAN ID is different from that already registered.
At least one VLAN ID must be specified if you use this command in dynamic VLAN mode
because a VLAN ID is changed to the specified VLAN ID by using this command after
authentication in dynamic VLAN mode.
To apply the setting to the internal MAC-based authentication DB, execute the
mac-authentication
Syntax
set mac-authentication mac-address
Input mode
Administrator mode
Parameters
<mac>
Specify the MAC address to be registered.
Specify the MAC address in the range from
you cannot specify a multicast MAC address (address in which the lowest bit of the first byte
is 1).
<vlan id>
Specify the VLAN ID of the VLAN to which the user will communicate after authentication.
For details about the specifiable range of values, see Specifiable values for parameters.
In dynamic VLAN mode, you must specify at least one VLAN ID for each MAC address.
Also, in dynamic VLAN mode, if you specify
occurs because that VLAN cannot be used as the post-authentication VLAN.
Operation when this parameter is omitted:
The VLAN ID is not checked at authentication time.
In dynamic VLAN mode, an authentication error occurs during authentication for the
specified MAC address.
Example
To add
0012.e200.1234
# set mac-authentication mac-address 0012.e200.1234 10
Display items
None
Impact on communication
None
212
command.
<mac>
as the MAC address and
<vlan id>
[ ]
to
0000.0000.0000 feff.ffff.ffff
as the VLAN ID, an authentication error
1
as the VLAN ID:
10
commit
. Note that