Table of Contents
Advertisement
10. Link Aggregation
channel-group lacp system-priority
Sets the LACP system priority of the applicable channel group for link aggregation.
Syntax
To set or change information:
channel-group lacp system-priority <priority>
To delete information:
no channel-group lacp system-priority
Input mode
(config-if)
Parameters
<priority>
Sets the LACP system priority. The lower the value, the higher the priority.
1.
Default value when this parameter is omitted:
This parameter cannot be omitted.
2.
Range of values:
1 to 65535
Default behavior
The setting of the
Impact on communication
If a priority is set for an active channel group, the channel group goes down, and then restarts.
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1.
This command is effective only when LACP-based link aggregation is used.
2.
If you set a restriction on the number of detached ports (
Switch to a device from other manufacturers, set a higher LACP system priority level for the
Switch.
3.
If the LACP system priority is changed, the status of all ports registered for the channel group
changes to
Related commands
interface port-channel
channel-group max-detach-port
138
lacp system-priority
(communication interrupted).
Blocking
command is used.
max-detach-port
) to connect a
- Quick Links:
- Corrections to the Manual
Hide quick links:
Advertisement
Table of Contents
