Configuring The Network Port On The Tapi Server; Configuring The Password For The Network Connection On The Tapi Server - Auerswald COMpact 5000 Operation Manual

Configuring the Network Port on the TAPI Server

According to the factory settings, the network port on the TAPI server is pre-defined at 7001 by
default.
Proceed as follows:
• Using the configuration manager
1. Open the page Functions > LAN TAPI.
2. In the Network port of the TAPI server (1024-65535) entry field, enter the port
number on the TAPI server. Possible entries:
1024 to
Note: The new configuration will only become effective after the PBX or the
TAPI server has been restarted.

Configuring the Password for the Network Connection on the TAPI Server

Proceed as follows:
• Using the configuration manager
1. Open the page Functions > LAN TAPI.
2. Enter the password in the Password for the network connection of the TAPI
server entry field. Possible entries:
8 to 32 digits
Digits: 0-
Characters: a- z, A- Z, no German umlauts and ß
Special characters
Note:
To change current passwords, click on
A coloured bar under the entry field shows the security level of the password
(red = low level, green = high level).
Passwords with a low security level can not be saved.
COMpact 5000/R - Firmware V6.6A - Installation, Operation and Configuration V05 03/2016
65535
9
- _ . ! ~ * ' ( ) & = + $ ,
Configuring the Network Port on the TAPI Server
Edit passwords.
Functions
LAN-TAPI
405