Reset Arp; Naturemask-Arp Enable - H3C S7500E Series Command Manual

Command Manual – ARP
H3C S7500E Series Ethernet Switches
Current ARP aging time is 10 minute(s)

1.1.7 naturemask-arp enable

Syntax
naturemask-arp enable
undo naturemask-arp enable
View
System view
Parameters
None
Description
Use the naturemask-arp enable command to cancel the restriction that ARP requests
must be from the same subnet. In this case, ARP requests from a natural network are
supported.
Use the undo naturemask-arp enable command to restore the default.
By default, the support for ARP requests from a natural network is disabled.
Examples
# Enable the support for ARP requests from a natural network.
<Sysname> system-view
[Sysname] naturemask-arp enable

1.1.8 reset arp

Syntax
reset arp { all | dynamic | slot slot-id | static | interface interface-type
interface-number }
View
User view
Parameters
all: Clears all ARP entries.
dynamic: Clears all dynamic ARP entries.
static: Clears all static ARP entries.
slot slot-id: Clears the ARP entries for the specified slot.
Chapter 1 ARP Configuration Commands
1-6