H3C S7500E Series Command Manual page 866

Command Manual – Multicast
H3C S7500E Series Ethernet Switches
Description
Use the display multicast rpf-info command to view the RPF information of a
multicast source.
Related
forwarding-table.
Examples
# View the RPF information of multicast source 192.168.1.55.
<Sysname> display multicast rpf-info 192.168.1.55
RPF information about source 192.168.1.55:
RPF interface: Vlan-interface1, RPF neighbor: 10.1.1.1
Referenced route/mask: 192.168.1.0/24
Referenced route type: igp
Route selection rule: preference-preferred
Load splitting rule: disable
Table 6-6 Description on the fields of the display multicast rpf-info command
RPF information about source
192.168.1.55
RPF interface
RPF neighbor
Referenced route/mask
Referenced route type
Route selection rule
Load splitting rule
commands: display
Field
Chapter 6 Multicast Routing and Forwarding
multicast routing-table,
Description
Information of the RPF path to multicast source
192.168.1.55
RPF interface
IP address of the RPF neighbor
Referenced route and its mask length
Type of the referenced route, which can be any of
the following:
igp: unicast route (IGP)
egp: unicast route (BGP)
unicast (direct):
connected)
unicast: other unicast route (such as unicast
static route)
multicast static: multicast static route
Rule for RPF route selection, which can be based
on the preference of the routing protocol or based
on the longest match on the destination address
Status of the load splitting rule (enabled/disabled)
6-8
Configuration Commands
display multicast
unicast route (directly