Display Radius Scheme - H3C S7500E Series Command Manual

Command Manual – AAA RADIUS HWTACACS
H3C S7500E Series Ethernet Switches
Description
Use the data-flow-format command to specify the unit for data flows or packets to be
sent to a RADIUS server.
Use the undo data-flow-format command to restore the default.
By default, the unit for data flows is byte and that for data packets is one-packet.
Related commands: display radius scheme.
Examples
# Define RADIUS scheme radius1 to send data flows and packets destined for the
RADIUS server in kilobytes and kilo-packets.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] data-flow-format data kilo-byte packet kilo-packet

1.2.2 display radius scheme

Syntax
display radius scheme [ radius-scheme-name ] [ slot slot-number ]
View
Any view
Parameters
radius-scheme-name: RADIUS scheme name.
slot slot-number: Specifies the slot where the interface card is inserted.
Description
Use the display radius scheme command to display the configuration information of a
specified RADIUS scheme or all RADIUS schemes.
Related commands: radius scheme.
Examples
# Display the configurations of all RADIUS schemes.
<Sysname> display radius scheme
------------------------------------------------------------------
SchemeName
Index=0
Primary Auth IP
Primary Acct IP
Second
= radius1
= 1.1.1.1
= 1.1.1.1
Auth IP = 0.0.0.0
Chapter 1 AAA/RADIUS/HWTACACS
Type=extended
Port = 1812
Port = 1813
Port = 1812
1-33
Configuration Commands
State = active
State = active
State = block