Display Startup; Reset Saved-Configuration - H3C S7500E Series Command Manual

Command Manual – File System Management
H3C S7500E Series Ethernet Switches
#
return
The configurations are displayed in the order of global, port, and user interface.

1.2.3 display startup

Syntax
display startup
View
Any view
Parameters
None
Description
Use the display startup command to display the configuration file used at this startup
and the one used for next startup.
Note that:
The SMB is started and run based on the current configurations of the AMB;
therefore the current startup configuration files displayed on the AMB and SMB
are always the same.
After switchover between the AMB and SMB, the new AMB does not restart from
the configuration file and runs with the current configuration instead. Therefore,
when you use the display startup command to view the configuration file, the
current startup configuration file of the new AMB is NULL and that of the new SMB
is also NULL to keep consistent with the new AMB.
Related commands: startup saved-configuration.
Examples
# Display the configuration file used at this startup and the one used for next startup.
<Sysname> display startup
MainBoard:
Current startup saved-configuration file:
Next startup saved-configuration file:

1.2.4 reset saved-configuration

Syntax
reset saved-configuration
Chapter 1 File System Management Commands
1-16
flash:/testcfg.cfg
flash:/testcfg.cfg