H3C S7500E Series Command Manual page 1506

Command Manual – RRPP
H3C S7500E Series Ethernet Switches
ring-id: RRPP ring ID, in the range 1 to 64.
Description
Use the display rrpp statistics command to display RRPP message statistics.
Note that:
If you have specified an RRPP ring ID in the command, RRPP message statistics
of the specified RRPP ring in the specified RRPP domain on the current device
appears. Otherwise, RRPP message statistics of all RRPP rings in the specified
RRPP domain appears.
If some port belongs to more than one ring, its packets are taken statistics based
on the rings. You will view the statistics of the port under the current ring.
When a ring transits from inactive status into active status, its packets will be taken
statistics again.
Related commands: reset rrpp statistics.
Examples
# Display RRPP message statistics of ring 1 in RRPP domain 1.
<Sysname> display rrpp statistics domain 1 ring 1
Ring ID
Ring Level
Node Mode
Active Status : Yes
Primary port
Packet
Direct Health
------------------------------------------------------------------------
Send
Rcv
Secondary port: GigabitEthernet3/0/2
Packet
Direct Health
------------------------------------------------------------------------
Send
Rcv
# Display RRPP message statistics of RRPP domain 2.
<Sysname> display rrpp statistics domain 2
Ring ID
Ring Level
Node Mode
Active Status : Yes
Primary port
: 1
: 1
: Master
: GigabitEthernet3/0/1
Link
Down
16424 0
0 0
Link
Down
0 0
16378 0
: 1
: 0
: Master
: GigabitEthernet3/0/3
Chapter 1 RRPP Configuration Commands
Common Complete
Flush FDB Flush FDB
0 1
0 0
Common Complete
Flush FDB Flush FDB
0 0
0 1
1-4
Packet
Total
16425
0
Packet
Total
0
16379