H3C S7500E Series Command Manual page 1512

Command Manual – RRPP
H3C S7500E Series Ethernet Switches
View
RRPP domain view
Parameters
ring-id: RRPP ring ID, in the range 1 to 64.
master: Specifies the device as the master node of the RRPP ring.
transit: Specifies the device as the transit node of the RRPP ring.
primary-port: Specifies the port as a primary port.
secondary-port: Specifies the port as a secondary port.
interface-type interface-number: Port type and port number.
level-value: RRPP ring level, with 0 representing primary ring and 1 representing
subring.
edge: Specifies the device as the edge node of the RRPP ring.
assistant-edge: Specifies the device as the assistant edge node of the RRPP ring.
common-port: Specifies the port as a common port.
edge-port: Specifies the port as an edge port.
Description
Use the ring command to configure the node mode of the device and the role of the
port accessing the RRPP ring.
Use the undo ring command to remove the configuration.
The ports accessing the RRPP ring must conform to the following conditions:
Trunk port;
Layer 2 Ethernet port or layer 2 GE port;
Except for aggregation port and loopback port;
Port with STP, 802.1x, MAC address authentication, voice VLAN disabled;
Note that:
RRPP ports cannot be configured if the RRPP ring is enabled.
You must first configure control the VLAN before configuring the RRPP ring.
You must first configure the primary ring and then the subring when configuring an
RRPP domain. A Ring ID cannot be applied to more than one RRPP ring in the
same RRPP domain.
If a device resides on multiple RRPP rings in an RRPP domain, only one primary
ring exists within these rings. The device plays a role of either edge node or
assistant edge node on other subrings.
Modifying the node mode, port mode and ring level of an RRPP ring is prohibited
after configuration. If needed, you must first delete the existing configuration.
Chapter 1 RRPP Configuration Commands
1-10