Chapter 5 Ipv6 Bgp Configuration Commands - H3C S7500E Series Command Manual

Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches

Chapter 5 IPv6 BGP Configuration Commands

Note:
At present, the LSQ1GP12EA boards in the S7500E series do not support IPv6.
5.1 IPv6 BGP Configuration Commands
5.1.1 balance
Syntax
balance number
undo balance
View
IPv6 address family view
Parameters
number: Number of BGP4+ routes participating in load balancing. Its value is in the
range 1 to 4. When it is set to 1, load balancing is disabled.
Description
Use the balance command to configure the number of routes participating in IPv6 BGP
load balancing.
Use the undo balance command to restore the default.
The feature is not available by default.
Unlike IGP, BGP has no explicit metric for making load balancing decision. Instead, it
implements load balancing by defining its routing rule.
Examples
# Set the number of routes participating in IPv6 BGP load balancing to 2.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] balance 2
Chapter 5 IPv6 BGP Configuration Commands
5-1