Info-Center Source - H3C S7500E Series Command Manual

Command Manual – Information Center
H3C S7500E Series Ethernet Switches
Description
Use the info-center snmp channel command to configure the channel to output
system information to the SNMP NMS.
Use the undo info-center snmp channel command to restore the default channel to
output system information to the SNMP NMS.
By default, output of system information to the SNMP NMS is enabled with a default
channel name of snmpagent and a default channel number of 5.
For more information, refer to the display snmp-agent command in the SNMP-RMON
Commands.
Examples
# Set to output system information to the SNMP NMS through channel 6.
<Sysname> system-view
[Sysname] info-center snmp channel 6

1.1.20 info-center source

Syntax
info-center source { module-name | default } channel { channel-number |
channel-name } [ debug { level severity | state state } * | log { level severity | state
state } * | trap { level severity | state state } * ] *
undo info-center source { module-name | default } channel { channel-number |
channel-name }
View
System view
Parameters
module-name: Specifies the output rules of the system information of the specified
modules, which vary with devices. For instance, if information on ARP module is to be
output, you can configure this argument as ARP.
default: Specifies the output rules of the system information of all the modules allowed
to output the system information. This configuration varies with devices.
debug: Debugging information.
log: Log information.
trap: Trap information.
level severity: Specifies the severity of system information, refer to
state state: The state of system information output, which could be on (enabled) or off
(disabled).
Chapter 1 Information Center Configuration
1-20
Commands
Table 1-4 for details.