Pim Bsr-Boundary - H3C S7500E Series Command Manual

Command Manual – Multicast
H3C S7500E Series Ethernet Switches
Parameters
None
Description
Use the pim command to enter PIM view.
Use the undo pim command to remove all configurations performed in PIM view.
IP multicast must be enabled on the device before this command can take effect.
Examples
# Enable IP multicast routing and enter PIM view.
<Sysname> system-view
[Sysname] multicast routing-enable
[Sysname] pim
[Sysname-pim]

4.1.34 pim bsr-boundary

Syntax
pim bsr-boundary
undo pim bsr-boundary
View
Interface view
Parameters
None
Description
Use the pim bsr-boundary command to configure a BSR admin-scope region
boundary on the current interface.
Use the undo pim bsr-boundary command to remove the configured BSR
admin-scope region boundary.
By default, no BSR admin-scope region boundary is configured.
Examples
# Configure VLAN-interface 100 to be the boundary of the BSR admin-scope region.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim bsr-boundary
Chapter 4 PIM Configuration Commands
4-34