Reset Radius Statistics; Radius Trap - H3C S7500E Series Command Manual

Command Manual – AAA RADIUS HWTACACS
H3C S7500E Series Ethernet Switches

1.2.12 radius trap

Syntax
radius trap { accounting-server-down | authentication-server-down }
undo radius trap { accounting-server-down | authentication-server-down }
View
System view
Parameters
accounting-server-down: RADIUS trap for accounting servers.
authentication-server-down: RADIUS trap for authentication servers.
Description
Use the radius trap command to enable the RADIUS trap function.
Use the undo radius trap command to disable the function.
By default, the RADIUS trap function is disabled.
Note that:
If a NAS sends an accounting or authentication request to the RADIUS server but
gets no response, the NAS retransmits the request. With the RADIUS trap function
enabled, when the NAS transmits the request for half of the specified maximum
number of transmission attempts, it sends a trap message; when the NAS
transmits the request for the specified maximum number, it sends another trap
message.
If the specified maximum number of transmission attempts is odd, the half of the
number refers to the smallest integer greater than the half of the number.
Examples
# Enable the RADIUS trap function for accounting servers.
<Sysname> system-view
[Sysname] radius trap accounting-server-down

1.2.13 reset radius statistics

Syntax
reset radius statistics [ slot slot-number ]
View
User view
Chapter 1 AAA/RADIUS/HWTACACS
1-46
Configuration Commands