H3C S7500E Series Command Manual page 1121

Command Manual – QoS
H3C S7500E Series Ethernet Switches
2.1.2 if-match
Syntax
if-match match-criteria
undo if-match match-criteria
View
Class view
Parameters
match-criteria: Matching rule to be defined.
this argument.
Table 2-2 The forms of the match-criteria argument
acl access-list-number
acl ipv6
access-list-number
any
customer-dot1p
8021p-list
dscp dscp-list
destination-mac
mac-address
ip-precedence
ip-precedence-list
protocol
protocol-name
Field
Specifies an ACL to match packets. The
access-list-number argument is in the range 2000 to 4999.
In a class configured with the operator and, the logical
relationship between rules defined in the referenced IPv4
ACL is or.
Specifies an IPv6 ACL to match IPv6 packets. The
access-list-number argument is in the range 2000 to 3999.
In a class configured with the operator and, the logical
relationship between rules defined in the referenced IPv6
ACL is or.
Specifies to match all packets.
Specifies to match packets by 802.1p precedence of the
customer network. The 8021p-list argument is a list of CoS
values. You can provide up to eight space-separated CoS
values for this argument. CoS is in the range 0 to 7.
Specifies to match packets by DSCP precedence. The
dscp-list argument is a list of DSCP values. You can
provide up to eight space-separated DSCP values for this
argument. DSCP is in the range 0 to 63.
Specifies to match the packets with a specified destination
MAC address.
Specifies to match packets by IP precedence. The
ip-precedence-list argument is a list of IP precedence
values. You can provide up to eight space-separated IP
precedence values for this argument. IP precedence is in
the range 0 to 7.
Specifies to match the packets of a specified protocol. The
protocol-name argument can be IP or IPv6.
Chapter 2 QoS Policy Configuration Commands
Table 2-2 describes the available forms of
Description
2-2