H3C S7500E Series Command Manual page 975

Command Manual – AAA RADIUS HWTACACS
H3C S7500E Series Ethernet Switches
Parameters
ip-address: IP address in dotted decimal notation. It must be an address of the device
and cannot be all 0s address, all 1s address, a class D address, a class E address or a
loopback address.
Description
Use the nas-ip command to set the IP address for the device to use as the source
address of the HWTACACS packets to be sent to the server.
Use the undo nas-ip command to remove the configuration.
By default, the source IP address of a packet sent to the server is the IP address of the
outbound port.
Note that:
Specifying a source address for the HWTACACS packets to be sent to the server
can avoid the situation where the packets sent back by the HWTACACS server
cannot reach the device as the result of a physical interface failure.
If you configure the command for more than one time, the last configuration takes
effect.
The nas-ip command in HWTACACS scheme view is only for the current
HWTACACS scheme, while the hwtacacs nas-ip command in system view is for
all HWTACACS schemes. However, the nas-ip command in HWTACACS
scheme view overwrites the configuration of the hwtacacs nas-ip command.
Related commands: hwtacacs nas-ip.
Examples
# Set the IP address for the device to use as the source address of the HWTACACS
packets to 10.1.1.1.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] nas-ip 10.1.1.1
1.3.8 primary accounting
Syntax
primary accounting ip-address [ port-number ]
undo primary accounting
View
HWTACACS scheme view
Chapter 1 AAA/RADIUS/HWTACACS
1-66
Configuration Commands