H3C S7500E Series Command Manual page 1378

Command Manual – System Maintaining and Debugging
H3C S7500E Series Ethernet Switches
Laser bias current fault
Laser temperature fault
Laser output power fault
TX fault
PMA/PMD receiver local fault
PCS receive local fault
PHY XS receive local fault
TX bias high
TX bias low
TX power high
TX power low
Temp high
Temp low
Transceiver info I/O error
Transceiver info checksum error
Transceiver type and port
configuration mismatch
Transceiver type not supported by
port hardware
Note:
For pluggable transceivers supported by S7500E series Ethernet switches, refer to
H3C S7500E Series Ethernet Switches Installation Manual.
Examples
# Display the alarm information of the transceiver on interface GigabitEthernet 2/0/1.
<Sysname> display transceiver alarm interface gigabitethernet 2/0/1
GigabitEthernet2/0/1 transceiver current alarm information:
TX fault
Field
3-15
Chapter 3 Device Management Commands
Remarks
Laser bias current fault
Laser temperature fault
Laser output power fault
TX fault
PMA/PMD receiver local fault
PCS receive local fault
PHY XS receive local fault
TX bias current is high.
TX bias current is low.
TX power is high.
TX power is low.
Temperature is high.
Temperature is low.
Transceiver information read and write error
Transceiver information checksum error
Transceiver type does not match port
configuration.
Transceiver type is not supported on the port.