Info-Center Loghost - H3C S7500E Series Command Manual

Command Manual – Information Center
H3C S7500E Series Ethernet Switches

1.1.16 info-center loghost

Syntax
info-center loghost host-ip [ channel { channel-number | channel-name } | facility
local-number ] *
undo info-center loghost host-ip
View
System view
Parameters
host-ip: The IP address of the log host.
channel: Specifies the channel through which system information can be output to the
log host.
channel-number: Specifies a channel number, in the range 0 to 9.
channel-name: Specifies a channel name, which could be a default name or a
self-defined name. The user needs to specify a channel name first before using it as a
self-defined channel name. For more information, refer to the info-center channel
name command.
facility local-number: The logging facility of the log host. The local-number argument
ranges from local0 to local7, with the corresponding value ranging from 16 to 23. The
default logging facility is local7, with the value being 23. Logging facility is mainly used
to mark the log sources on the log host, query and filter log information of the
corresponding log source.
Description
Use the info-center loghost command to specify a log host and to configure the
related parameters.
Use the undo info-center loghost command to restore the default configurations on a
log host.
By default, output of system information to the log host is disabled. When it is enabled,
the default channel name will be loghost and the default channel number will be 2.
Note that:
The info-center loghost command takes effect only after the information center is
enabled with the info-center enable command.
Ensure to input a correct IP address while using the info-center loghost
command to configure the IP address for a log host. System will prompt an invalid
address if the loopback address (127.0.0.1) is input.
A maximum number of 4 hosts (different) can be designated as the log host.
Chapter 1 Information Center Configuration
1-17
Commands