H3C S7500E Series Command Manual page 847

Command Manual – Multicast
H3C S7500E Series Ethernet Switches
Examples
# Configure the MSDP peer to advertise only the (S, G) entries of multicast sources on
the 10.10.0.0/16 subnet and with multicast group address of 225.1.0.0/16 when
creating an SA message.
<Sysname> system-view
[Sysname] acl number 3101
[Sysname-acl-adv-3101]
destination 225.1.0.0 0.0.255.255
[Sysname-acl-adv-3101] quit
[Sysname] msdp
[Sysname-msdp] import-source acl 3101
5.1.8 msdp
Syntax
msdp
undo msdp
View
System view
Parameters
None
Description
Use the msdp command to enable MSDP and enter MSDP view.
Use the undo msdp command to disable MSDP and remove the configurations
performed in MSDP view to free the resources occupied by MSDP.
By default, MSDP is disabled.
Examples
# Enable MSDP and enter MSDP view.
<Sysname> system-view
[Sysname] multicast routing-enable
[Sysname] msdp
[Sysname-msdp]
Chapter 5 MSDP Configuration Commands
rule permit ip
5-10
source 10.10.0.0 0.0.255.255