H3C S7500E Series Command Manual page 980

Command Manual – AAA RADIUS HWTACACS
H3C S7500E Series Ethernet Switches
Description
Use the retry stop-accounting command to set the maximum number of
stop-accounting request transmission attempts.
Use the undo retry stop-accounting command to restore the default.
Related commands: reset stop-accounting-buffer, hwtacacs scheme, display
stop-accounting-buffer.
Examples
# Set the maximum number of stop-accounting request transmission attempts to 50.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] retry stop-accounting 50
1.3.14 secondary accounting
Syntax
secondary accounting ip-address [ port-number ]
undo secondary accounting
View
HWTACACS scheme view
Parameters
ip-address: IP address of the server, a valid unicast address in dotted decimal notation.
The default is 0.0.0.0.
port-number: Port number of the server. It ranges from 1 to 65535 and defaults to 49.
Description
Use the secondary accounting command to specify the secondary HWTACACS
accounting server.
Use the undo secondary accounting command to remove the configuration.
Note that:
The IP addresses of the primary and secondary accounting servers cannot be the
same. Otherwise, the configuration fails.
The HWTACACS service port configured on the device and that of the
HWTACACS server must be consistent.
If you configure the command for more than one time, the last configuration takes
effect.
You can remove an accounting server only when no active TCP connection for
sending accounting packets is using it.
Chapter 1 AAA/RADIUS/HWTACACS
1-71
Configuration Commands