H3C S7500E Series Command Manual page 1406

Command Manual – HA
H3C S7500E Series Ethernet Switches
View
Any view
Parameters
verbose: Displays detailed state information of VRRP.
interface interface-type interface-number: Displays VRRP state information of the
specified interface. interface-type interface-number specifies an interface by its type
and number.
vrid virtual-router-id: Displays state information of the specified VRRP group.
virtual-router-id specifies a standby group by its group number, in the range 1 to 255.
Description
Use the display vrrp ipv6 command to display the state information of VRRP for IPv6.
If you do not specify verbose, only the brief state information of VRRP is displayed.
If you specify both interface and standby group, only the state information of the
specified standby group is displayed; if you only specify an interface, the state
information of all the standby groups on the interface is displayed; if you specify neither,
the state information of all the standby groups on the device is displayed.
Examples
# Display brief information about all VRRP standby groups on the device for IPv6.
<Sysname> display vrrp ipv6
IPv6 Standby Information:
Run Method
Virtual IP Ping : Enable
The total number of the vitual routers: 1
Interface
---------------------------------------------------------------------
Vlan100
# Display detailed information about all standby groups on the device.
<Sysname>display vrrp ipv6 verbose
IPv6 Standby Information:
Run Method
Virtual IP Ping : Enable
Interface
VRID
Admin Status
Config Pri
Preempt Mode
: VIRTUAL-MAC
VRID State
1 Master
: VIRTUAL-MAC
: Vlan-interface100
: 1
: UP
: 100
: YES
1-14
Chapter 1 VRRP Configuration Commands
Run Adver. Auth
Pri Time Type
100 100 NONE
Adver. Timer : 100
State : Master
Run Pri : 100
Delay Time : 0
Virtual
IP
FE80::1