Vrrp Ipv6 Vrid Timer Advertise; Vrrp Ipv6 Vrid Track - H3C S7500E Series Command Manual

Command Manual – HA
H3C S7500E Series Ethernet Switches

1.2.9 vrrp ipv6 vrid timer advertise

Syntax
vrrp ipv6 vrid virtual-router-id timer advertise adver-interval
undo vrrp ipv6 vrid virtual-router-id timer advertise
View
Interface view
Parameters
virtual-router-id: VRRP standby group number, in the range 1 to 255.
adver-interval: Interval at which the master in the specified standby group sends VRRP
advertisements. It ranges from 100 to 4095 centiseconds.
Description
Use the vrrp ipv6 vrid timer advertise command to configure the Adver_Timer of the
specified standby group.
Use the undo vrrp ipv6 vrid timer advertise command to restore the default.
By default the Adver_Timer is 100 centiseconds.
The Adver_Timer controls the interval at which the master sends VRRP packets.
Before executing the command, create a standby group on an interface and
configure the virtual IPv6 address of the standby group.
Routers in the same VRRP standby group must use the same Adver_Timer
setting.
Examples
# Set the master in standby group 1 to send VRRP advertisements at intervals of 500
centiseconds.
<Sysname> system-view
[Sysname] interface vlan-interface 2
[Sysname-Vlan-interface2] vrrp ipv6 vrid 1 virtual-ip fe80::2 link-local
[Sysname-Vlan-interface2] vrrp ipv6 vrid 1 timer advertise 500

1.2.10 vrrp ipv6 vrid track

Syntax
vrrp ipv6 vrid virtual-router-id track interface interface-type interface-number
[ reduced priority-reduced ]
undo vrrp ipv6 vrid virtual-router-id track [ interface interface-type interface-number ]
Chapter 1 VRRP Configuration Commands
1-23