Peer Sa-Cache-Maximum - H3C S7500E Series Command Manual

Command Manual – Multicast
H3C S7500E Series Ethernet Switches
By default, no SA request message is sent.
Note that before you can enable the device to send SA requests, you must disable the
SA message cache mechanism.
Related commands: cache-sa-enable.
Examples
# Disable the SA message cache mechanism, and enable the router to send an SA
request message to the MSDP peer 125.10.7.6 upon receiving a new Join message.
<Sysname> system-view
[Sysname] msdp
[Sysname-msdp] undo cache-sa-enable
[Sysname-msdp] peer 125.10.7.6 request-sa-enable

5.1.15 peer sa-cache-maximum

Syntax
peer peer-address sa-cache-maximum sa-limit
undo peer peer-address sa-cache-maximum
View
MSDP view
Parameters
peer-address: MSDP peer address.
sa-limit: Maximum number of SA messages that the device can cache, in the range of 1
to 8,192.
Description
Use the peer sa-cache-maximum command to configure the maximum number of SA
messages that the device can cache.
Use the undo peer sa-cache-maximum command to restore the default setting.
By default, the device can cache a maximum of 8,192 SA messages.
Related commands: display msdp sa-count, display msdp peer-status, display
msdp brief.
Examples
# Allow the device to cache a maximum of 100 SA messages from the MSDP peer
125.10.7.6.
<Sysname> system-view
[Sysname] msdp
Chapter 5 MSDP Configuration Commands
5-15