H3C S7500E Series Command Manual page 845

Command Manual – Multicast
H3C S7500E Series Ethernet Switches
Number of source and group, counted by AS
AS
?
Total 5 Source-Active entries
Table 5-4 Description on the fields of the display msdp sa-count command
Number of cached Source-Active
entries, counted by Peer
Peer's Address
Number of SA
AS
Number of source
Number of group
5.1.6 encap-data-enable
Syntax
encap-data-enable
undo encap-data-enable
View
MSDP view
Parameters
None
Description
Use the encap-data-enable command to enable register message encapsulation in SA
messages.
Use the undo encap-data-enable command to disable register message
encapsulation in SA messages.
By default, an SA message contains only an (S, G) entry. No register message is
encapsulated in an SA message.
Number of source
3
Field
Chapter 5 MSDP Configuration Commands
Number of group
3
Number of SA messages per peer
MSDP peer addresses
Number of SA messages from this peer
Number of the AS where the MSDP peer is
located. "?" indicates that the system was
unable to obtain the AS number.
Number of multicast sources from this AS
Number of multicast groups from this AS
5-8
Description