Igmp-Snooping Group-Policy - H3C S7500E Series Command Manual

Command Manual – Multicast
H3C S7500E Series Ethernet Switches
If you do not specify any VLAN in Ethernet interface view, the command will take
effect on the port no matter which VLAN the port belongs to; if you specify a VLAN
or multiple VLANs, the command will take effect on the port only if the port belongs
to the specified VLAN(s).
If you do not specify any VLAN in port group view, the command will take effect on
all the ports in this group no matter which VLANs these ports belong to; if you
specify a VLAN or multiple VLANs, the command will take effect on those ports in
this group that belong to the specified VLAN(s).
Examples
# Specify to allow a maximum of 10 multicast groups to be joined on Ethernet 2/0/1,
which belongs to VLAN 2.
<Sysname> system-view
[Sysname] interface ethernet 2/0/1
[Sysname-Ethernet2/0/1] igmp-snooping group-limit 10 vlan 2

1.1.13 igmp-snooping group-policy

Syntax
igmp-snooping group-policy acl-number [ vlan vlan-list ]
undo igmp-snooping group-policy [ vlan vlan-list ]
View
Ethernet interface view, port group view
Parameters
acl-number: Basic ACL number, in the range of 2000 to 2999.
vlan vlan-list: Defines one or multiple VLANs. You can provide up to 10 VLAN lists, by
each of which you can specify an individual VLAN in the form of vlan-id, or a VLAN
range in the form of start-vlan-id to end-vlan-id, where the end VLAN ID must be
greater than the start VLAN ID. The effective range of a VLAN ID is 1 to 4094.
Description
Use the igmp-snooping group-policy command to configure a multicast group filter
on the current port(s).
Use the undo igmp-snooping group-policy command to remove a multicast group
filter on the current port(s).
Be default, no multicast group filter is configured on an interface, namely a host can join
any multicast group
Note that:
Chapter 1 IGMP Snooping Configuration Commands
1-12