H3C S7500E Series Command Manual page 1165

Command Manual – Port Mirroring
H3C S7500E Series Ethernet Switches
Parameters
group-id: Port mirroring group number, in the range of 1 to 4.
monitor-egress-port-id: Index of the port to be configured as the outbound mirroring
port. You need to provide this argument in the format of { interface-type
interface-number }, where interface-type is port type and interface-number is port
number.
Description
Use the mirroring-group monitor-egress command to configure a port as the
outbound mirroring port of a remote port mirroring group.
Use the undo mirroring-group monitor-egress command to remove the outbound
mirroring port configured from a remote port mirroring group.
Note that:
Only remote source port mirroring groups can have outbound mirroring ports. A
port mirroring group can have only one outbound mirroring port.
The outbound port cannot be a member port of the current mirroring group.
It is not recommended to configure STP, RSTP, MSTP, 802.1x, IGMP Snooping,
static ARP and MAC address learning on the outbound mirroring port; otherwise,
the mirroring function may be affected.
Examples
# Configure port Ethernet 2/0/1 as the outbound mirroring port of remote port mirroring
group 1 in system view.
<Sysname> system-view
[Sysname] mirroring-group 1 remote-source
[Sysname] mirroring-group 1 monitor-egress Ethernet 2/0/1
# Configure port Ethernet 2/0/2 as the outbound mirroring port of remote port mirroring
group 2 in Ethernet port view.
<Sysname> system-view
[Sysname] mirroring-group 2 remote-source
[Sysname] interface Ethernet 2/0/2
[Sysname-Ethernet2/0/2] mirroring-group 2 monitor-egress
1.1.5 mirroring-group monitor-port
Syntax
mirroring-group group-id monitor-port monitor-port-id
undo mirroring-group group-id monitor-port monitor-port-id
Chapter 1 Port Mirroring Configuration Commands
1-5