Ipv6 Host - H3C S7500E Series Command Manual

Command Manual – IPv6 Configuration
H3C S7500E Series Ethernet Switches
Parameters
ipv6-address: IPv6 link-local address. The first ten bits of an address must be
1111111010 (binary), that is, the first group of hexadecimals in the address must be
FE80 to FEBF.
Description
Use the ipv6 address link-local command to configure a link-local address manually
for a specified interface. Use the undo ipv6 address link-local command to remove
the configured link-local address for an interface.
Examples
# Configure a link-local address for VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 address fe80::1 link-local

1.1.20 ipv6 host

Syntax
ipv6 host hostname ipv6-address
undo ipv6 host hostname [ ipv6-address ]
View
System view
Parameters
hostname: Host name, a string of up to 20 characters. The character string can contain
letters, numerals, "_", "-", or "." and must contain at least one letter.
ipv6-address: IPv6 address.
Description
Use the ipv6 host command to configure the mappings between host names and IPv6
addresses.
Use the undo ipv6 host command to remove the mappings between host names and
IPv6 addresses.
Each host name can correspond to only one IPv6 address.
Examples
# Configure the mapping between a host name and an IPv6 address.
<Sysname> system-view
Chapter 1 IPv6 Basics Configuration Commands
1-26