Poe Pd-Description - H3C S7500E Series Command Manual

Command Manual – PoE
H3C S7500E Series Ethernet Switches
Description
Use the poe mode command to configure a PoE mode.
Use the undo poe mode command to restore the default.
By default, the PoE mode is signal (power over signal cables).
The PSE supplies power for a PoE interface in the following two modes: signal and
spare.
In the signal mode, lines in Category 3 and 5 twisted pair cables used for
transmitting data are also used for supplying DC power.
In the spare mode, lines in Category 3 and 5 twisted pair cables not in use are
used for supplying DC power.
Currently, the S7500E series switches do not support the spare mode.
Examples
# Set the PoE mode to signal (power over signal cables).
<Sysname> system-view
[Sysname] interface Ethernet 2/0/2
[Sysname-Ethernet2/0/2] poe mode signal
# Set the PoE mode to signal (power over signal cables) through a PoE configuration
file.
<Sysname> system-view
[Sysname] poe-profile abc
[Sysname-poe-profile-abc-1] poe mode signal
[Sysname-poe-profile-abc-1] quit
[Sysname] interface Ethernet 2/0/2
[Sysname-Ethernet2/0/2] apply poe-profile name abc

1.1.24 poe pd-description

Syntax
poe pd-description string
undo poe pd-description
View
PoE interface view
Parameters
string: Description of the PD connected to a PoE interface, a string of 1 to 80
characters.
Chapter 1 PoE Configuration Commands
1-30