H3C S7500E Series Command Manual page 614

Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches
Table 5-5 Description on the fields of the display bgp ipv6 routing-table command
Field
Local router ID
Status codes
Origin
Network
PrefixLen
NextHop
MED
LocPrf
Path
PrefVal
Label
Ogn
Local router ID
Status codes:
* – valid
> – best
d – damped
h – history
i – internal (IGP)
s – summary suppressed (suppressed)
S – Stale
i – IGP (originated in the AS)
e – EGP (learned through EGP)
? – incomplete (learned by other means)
Destination network address
Prefix length
Next Hop
MULTI_EXIT_DISC attribute
Local preference value
AS_PATH attribute, recording the ASs the packet has passed to
avoid routing loops
Preferred value
Label
Origin attribute of the route, which can take on one of the following
values:
Indicates that a route is interior to the AS.
i
Summary routes and the routes configured using the
network command are considered IGP routes.
Indicates that a route is learned from the exterior
e
gateway protocol (EGP).
Short for INCOMPLETE. It indicates that the origin of a
route is unknown and the route is learned by other
?
means. BGP sets Origin attribute of routes learned from
other IGP protocols to INCOMPLETE.
5-14
Chapter 5 IPv6 BGP Configuration Commands
Description