H3C S7500E Series Command Manual page 645

Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches
5.1.53 peer route-policy
Syntax
peer { ipv6-group-name | ipv6-address } route-policy route-policy-name { import |
export }
undo peer { ipv6-group-name | ipv6-address } route-policy route-policy-name
{ import | export }
View
IPv6 address family view
Parameters
ipv6-group-name: Name of an IPv6 peer group, a string of 1 to 47 characters.
ipv6-address: IPv6 address of a peer.
route-policy-name: Specifies route-policy name, a string of 1 to 19 characters.
import: Applies the routing policy to routes from the peer (group).
export: Applies the routing policy to routes to the peer (group).
Description
Use the peer route-policy command to apply a routing policy to routes incoming from
or outgoing to a peer or peer group.
Use the undo peer route-policy command to remove the configuration.
By default, no routing policy is specified for the peer (group).
Use of the peer route-policy command does not apply the if-match interface clause
defined in the routing policy. Refer to Routing Policy Commands in the part discussing
IPv4 routing for related information.
Examples
# Apply the routing policy test-policy to routes received from the peer group test.
<Sysname> system-view
[Sysname] route-policy test-policy permit node 10
[Sysname-route-policy] if-match cost 10
[Sysname-route-policy] apply cost 65535
[Sysname-route-policy] quit
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] group test external
[Sysname-bgp-af-ipv6] peer test route-policy test-policy import
Chapter 5 IPv6 BGP Configuration Commands
5-45