H3C S7500E Series Command Manual page 976

Command Manual – AAA RADIUS HWTACACS
H3C S7500E Series Ethernet Switches
Parameters
ip-address: IP address of the server, a valid unicast address in dotted decimal notation.
The default is 0.0.0.0.
port-number: Port number of the server. It ranges from 1 to 65535 and defaults to 49.
Description
Use the primary accounting command to specify the primary HWTACACS accounting
server.
Use the undo primary accounting command to remove the configuration.
Note that:
The IP addresses of the primary and secondary accounting servers cannot be the
same. Otherwise, the configuration fails.
The HWTACACS service port configured on the device and that of the
HWTACACS server must be consistent.
If you configure the command for more than one time, the last configuration takes
effect.
You can remove an accounting server only when no active TCP connection for
sending accounting packets is using it.
Examples
# Configure the primary accounting server.
<Sysname> system-view
[Sysname] hwtacacs scheme test1
[Sysname-hwtacacs-test1] primary accounting 10.163.155.12 49
1.3.9 primary authentication
Syntax
primary authentication ip-address [ port-number ]
undo primary authentication
View
HWTACACS scheme view
Parameters
ip-address: IP address of the server, a valid unicast address in dotted decimal notation.
The default is 0.0.0.0.
port-number: Port number of the server. It ranges from 1 to 65535 and defaults to 49.
Chapter 1 AAA/RADIUS/HWTACACS
1-67
Configuration Commands