Vrrp Ipv6 Vrid Virtual-Ip - H3C S7500E Series Command Manual

Command Manual – HA
H3C S7500E Series Ethernet Switches
View
Interface view
Parameters
virtual-router-id: VRRP standby group number, in the range 1 to 255.
interface interface-type interface-number: Specifies an interface by its type and
number.
reduced priority-reduced: Value by which the priority decrements. priority-reduced
ranges from 1 to 254 and defaults to 10.
Description
Use the vrrp ipv6 vrid track command to configure to track the specified interface.
Use the undo vrrp ipv6 vrid track command to disable tracking the specified
interface.
By default, no interface is being tracked.
Note that:
Before executing the command, create a standby group on an interface and
configure the virtual IPv6 address of the standby group.
When the switch is the owner of the IP address, you cannot perform the
configuration.
When the status of the tracked interface turns from down to up, the corresponding
switch restores its priority automatically.
Examples
# On interface VLAN-interface 2, set the interface to be tracked as VLAN-interface 1,
making the priority of standby group 1 on interface VLAN-interface 2 decrement by 50
when VLAN-interface 1 goes down.
<Sysname> system-view
[Sysname] interface vlan-interface 2
[Sysname-Vlan-interface2] vrrp ipv6 vrid 1 track interface vlan-interface 1
reduced 50

1.2.11 vrrp ipv6 vrid virtual-ip

Syntax
vrrp ipv6 vrid virtual-router-id virtual-ip virtual-address [link-local]
undo vrrp ipv6 vrid virtual-router-id [ virtual-ip virtual-address [ link-local ] ]
View
Interface view
Chapter 1 VRRP Configuration Commands
1-24