Display Saved-Configuration - H3C S7500E Series Command Manual

Command Manual – File System Management
H3C S7500E Series Ethernet Switches
View
User view
Parameters
dest-addr: IP address or name of a TFTP server. The address cannot be an IPv6
address.
dest-filename: Target filename used to save the next startup configuration file on the
server.
Description
Use the backup startup-configuration command to backup the startup configuration
file (for next startup) using a filename you specify. If you do not specify this filename,
the original filename is used.
This command only backs up the configuration file of the main board for next
startup.
This command backs up the configuration file for next startup.
Presently, the device uses TFTP to backup configuration files.
Examples
# Backup the configuration file for next startup on the TFTP server with IP address
2.2..2.2, using the filename config.cfg.
<Sysname> backup startup-configuration to 2.2.2.2 config.cfg
Backup next startup-configuration file to 2.2.2.2, please wait...
finished!
<Sysname>

1.2.2 display saved-configuration

Syntax
display saved-configuration [ by-linenum ]
View
Any view
Parameters
by-linenum: Identifies each line of displayed information with a line number.
Description
Use the display saved-configuration command to display the initial configuration file
saved in the storage device.
Chapter 1 File System Management Commands
1-14