Switch-Mode (For Srpu) - H3C S7500E Series Command Manual

Command Manual – System Maintaining and Debugging
H3C S7500E Series Ethernet Switches
Examples
# Set the detection interval to 100 seconds.
<Sysname> system-view
[Sysname] shutdown-interval 100

3.1.22 switch-mode (for SRPU)

Syntax
When the SRPU is LSQ1SRP1CB:
switch-mode { l2-enhanced | standard-bridging | standard-routing }
undo switch-mode
When the SRPU is LSQ1SRP2XB, LSQ1SRPB, or LSQ1MPUA:
switch-mode { l2-enhanced | standard }
undo switch-mode
View
System view
Parameters
l2-enhanced: Indicates the enhanced Layer 2 forwarding mode with the MAC
extension function when the SRPU is LSQ1SRP1CB, and the enhanced Layer 2
forwarding mode when the SRPU is LSQ1SRP2XB, LSQ1SRPB, or LSQ1MPUA.
standard: Indicates the standard forwarding mode.
standard-bridging: Indicates the standard forwarding mode with the MAC extension
function.
standard-routing: Indicates the standard forwarding mode with the route extension
function.
Description
Use the switch-mode command to configure the traffic forwarding mode of an SRPU.
Use the undo switch-mode command to restore the default traffic forwarding mode of
the SRPU.
The default traffic forwarding mode of LSQ1SRP1CB is standard-routing.
The default traffic forwarding mode of LSQ1SRP2XB, LSQ1SRPB, or LSQ1MPUA
is standard.
Chapter 3 Device Management Commands
3-25