Primary Authorization - H3C S7500E Series Command Manual

Command Manual – AAA RADIUS HWTACACS
H3C S7500E Series Ethernet Switches
Description
Use the primary authentication command to specify the primary HWTACACS
authentication server.
Use the undo primary authentication command to remove the configuration.
Note that:
The IP addresses of the primary and secondary authentication servers cannot be
the same. Otherwise, the configuration fails.
The HWTACACS service port configured on the device and that of the
HWTACACS server must be consistent.
If you configure the command for more than one time, the last configuration takes
effect.
You can remove an authentication server only when no active TCP connection for
sending authentication packets is using it.
Related commands: display hwtacacs.
Examples
# Set the primary authentication server.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] primary authentication 10.163.155.13 49

1.3.10 primary authorization

Syntax
primary authorization ip-address [ port-number ]
undo primary authorization
View
HWTACACS scheme view
Parameters
ip-address: IP address of the server, a valid unicast address in dotted decimal notation.
The default is 0.0.0.0.
port-number: Port number of the server. It ranges from 1 to 65535 and defaults to 49.
Description
Use the primary authorization command to specify the primary HWTACACS
authorization server.
Use the undo primary authorization command to remove the configuration.
Chapter 1 AAA/RADIUS/HWTACACS
1-68
Configuration Commands