Ipv6 Filter-Policy Export - H3C S7500E Series Command Manual

Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches
Parameters
None
Description
Use the ipv6 enable command to enable IPv6 for the IPv6 IS-IS process.
Use the undo ipv6 enable command to disable IPv6.
IPv6 is disabled by default.
Examples
# Create IS-IS routing process 1, and enable IPv6 for the process.
<Sysname> system-view
[Sysname] ipv6
[Sysname] isis 1
[Sysname-isis-1] network-entity 10.0001.1010.1020.1030.00
[Sysname-isis-1] ipv6 enable

4.1.4 ipv6 filter-policy export

Syntax
ipv6 filter-policy { acl6-number | ipv6-prefix ipv6-prefix-name | route-policy
route-policy-name } export [ protocol process-id ]
undo ipv6 filter-policy export [ protocol [ process-id ] ]
View
IS-IS view
Parameters
acl6-number: Number of a basic or advanced IPv6 ACL used to filter redistributed
routes before advertisement, ranging from 2000 to 3999.
ipv6-prefix-name: Name of an IPv6 prefix list used to filter the redistributed routes
before advertisement, a string of 1 to 19 characters.
route-policy-name: Name of a routing policy used to filter the redistributed routes
before advertisement, a string of 1 to 19 characters.
protocol: Filter routes redistributed from the specified routing protocol before
advertisement. The routing protocol can be bgp4+, direct, isisv6, ospfv3, ripng or
static at present. If no protocol is specified, routes redistributed from all protocols are
filtered before advertisement.
process-id: Process ID of the routing protocol, ranging from 1 to 65535. This argument
is available when the protocol is isisv6, ospfv3 or ripng.
Chapter 4 IPv6 IS-IS Configuration Commands
4-5