Display Multicast Rpf-Info - H3C S7500E Series Command Manual

Command Manual – Multicast
H3C S7500E Series Ethernet Switches
Running Configuration = ip rpf-route-static 10.10.0.0 16 2.2.2.2 order 1
# View the configuration information of multicast static routes.
<Sysname> display multicast routing-table static config
Multicast Routing Table
Routes : 1
Mroute 10.10.0.0/16,
Matched routing protocol = <none>, Route-policy = <none>
Preference = 1, Order = 1
Table 6-5 Description on the fields of display multicast routing-table static
Mroute
Interface
RPF Neighbor
Matched routing protocol
Route-policy
Preference
Order

6.1.5 display multicast rpf-info

Syntax
display multicast rpf-info source-address [ group-address ]
View
Any view
Parameters
source-address: Multicast source address.
group-address: Multicast group address, in the range of 224.0.1.0 to 239.255.255.255.
Preference = 1, Order = 1
interface = Vlan-interface1
Field
Multicast route source address and its mask length
Outgoing interface to the multicast source
IP address of the RPF neighbor through which the
multicast source is reachable
If a protocol is configured, the multicast source
address of the route should be the destination
address of an entry in unicast routing table.
Routing policy. The multicast source address of the
route should match the routing policy.
Route preference
Sequence number of the route
Chapter 6 Multicast Routing and Forwarding
Description
6-7
Configuration Commands