Remark Drop-Precedence - H3C S7500E Series Command Manual

Command Manual – QoS
H3C S7500E Series Ethernet Switches
Description
Use the remark dot1p command to configure the action of setting 802.1p precedence
for a traffic behavior.
Use the undo remark dot1p command to remove the action of setting 802.1p
precedence
Note that, when the remark dot1p command is used together with the remark
local-precedence command, the 802.1p precedence to be set for packets must be the
same as the local precedence to be set for packets. Otherwise, the corresponding
policy cannot be applied successfully..
Related commands: qos policy, traffic behavior, classifier behavior.
Examples
# Configure the action to set 802.1p precedence to 2 for a traffic behavior.
<Sysname> system-view
[Sysname] traffic behavior database
[Sysname-behavior-database] remark dot1p 2

2.2.9 remark drop-precedence

Syntax
remark drop-precedence drop-precedence-value
undo remark drop-precedence
View
Traffic behavior view
Parameters
drop-precedence-value: Drop precedence to be set for packets, in the range 0 to 2.
Description
Use the remark drop-precedence command to configure the action of setting drop
precedence for a traffic behavior.
Use the undo remark drop-precedence command to remove the action of setting
drop precedence.
Related commands: qos policy, traffic behavior, classifier behavior.
Examples
# Configure the action to set drop precedence to 2 for a traffic behavior.
<Sysname> system-view
[Sysname] traffic behavior database
Chapter 2 QoS Policy Configuration Commands
2-13