H3C S7500E Series Command Manual page 1166

Command Manual – Port Mirroring
H3C S7500E Series Ethernet Switches
View
System view
Parameters
group-id: Port mirroring group number, in the range of 1 to 4.
monitor-port-id: Port index. You need to provide this argument in the form of
interface-type interface-number, where interface-type is the port type and
interface-number is the port number.
Description
Use the mirroring-group monitor-port command to configure the destination port for
a port mirroring group.
Use the undo mirroring-group monitor-port command to remove the destination port
from a port mirroring group.
Note that:
A port mirroring group can contain only one destination port.
The destination port cannot be a member port of the current mirroring group.
The destination mirroring port can be an access, trunk, or hybrid port. It must be
assigned to the remote mirroring VLAN.
A remote source port mirroring group cannot contain destination ports.
Before configuring the destination port for a port mirroring group, make sure the
port mirroring group exists.
Do not enable STP, RSTP, or MSTP on the destination port. Otherwise, the
mirroring function may be affected.
Do not use the destination mirroring port for any purpose other than port mirroring.
Examples
# Configure Ethernet 2/0/1 as the destination port of port mirroring group 1 (a remote
destination port mirroring group).
<Sysname> system-view
[Sysname] mirroring-group 1 remote-destination
[Sysname] mirroring-group 1 monitor-port Ethernet 2/0/1
1.1.6 mirroring-group remote-probe vlan
Syntax
mirroring-group group-id remote-probe vlan rprobe-vlan-id
undo mirroring-group group-id remote-probe vlan rprobe-vlan-id
Chapter 1 Port Mirroring Configuration Commands
1-6