Ipv6 Import-Route Isisv6 Level-2 Into Level - H3C S7500E Series Command Manual

Hide thumbs Also See for S7500E Series:

Table of Contents

Command Manual – IPv6 Routing

H3C S7500E Series Ethernet Switches

allow-ibgp: Allows the redistribution of IBGP routes. This keyword is optional when the

protocol is bgp4+.

Use the ipv6 import-route command to enable IPv6 IS-IS to redistribute routes from

another routing protocol.

Use the undo ipv6 import-route command to disable route redistribution.

Route redistribution is disabled by default.

If no level is specified, the routes are imported to Level-2 routing table by default.

IPv6 IS-IS considers redistributed routes as routes to destinations outside the local

routing domain.

You can specify a cost and a level for redistributed routes.

Using the import-route bgp4+ allow-ibgp command will redistribute both EBGP and

IBGP routes. The redistributed IBGP routes may cause routing loops. Therefore, be

cautious with this command.

# Configure IPv6–IS-IS to redistribute static routes and sets the cost 15 for them.

<Sysname> system-view

[Sysname] isis

[Sysname-isis-1]ipv6 import-route static cost 15

4.1.7 ipv6 import-route isisv6 level-2 into level-1

ipv6 import-route isisv6 level-2 into level-1 [ filter-policy { acl6-number |

ipv6-prefix ipv6-prefix-name | route-policy route-policy-name } | tag tag ]*

undo ipv6 import-route isisv6 level-2 into level-1

Chapter 4 IPv6 IS-IS Configuration Commands

Table of Contents