H3C S7500E Series Command Manual page 963

Command Manual – AAA RADIUS HWTACACS
H3C S7500E Series Ethernet Switches
Use the undo server-type command to restore the default.
By default, the supported RADIUS server type is standard.
Related commands: radius scheme.
Examples
# Set the RADIUS server type of RADIUS scheme radius1 to standard.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] server-type standard
1.2.22 state
Syntax
state { primary | secondary } { accounting | authentication } { active | block }
View
RADIUS scheme view
Parameters
primary: Sets the status of the primary RADIUS server.
secondary: Sets the status of the secondary RADIUS server.
accounting: Sets the status of the RADIUS accounting server.
authentication: Sets the status of the RADIUS authentication/authorization server.
active: Sets the status of the RADIUS server to active, namely the normal operation
state.
block: Sets the status of the RADIUS server to block.
Description
Use the state command to set the status of a RADIUS server.
By default, every RADIUS server configured with an IP address in the RADIUS scheme
is in the state of active.
Note that:
When a primary server, authentication/authorization server or accounting server,
fails, the device automatically turns to the secondary server.
Once the primary server fails, the primary server turns into the state of block, and
the device turns to the secondary server. In this case, if the secondary server is
available, the device triggers the primary server quiet timer. After the quiet timer
times out, the status of the primary server is active again and the status of the
Chapter 1 AAA/RADIUS/HWTACACS
1-54
Configuration Commands