H3C S7500E Series Command Manual page 1210

Command Manual – SNMP-RMON
H3C S7500E Series Ethernet Switches
Parameters
entry-number: Event entry index, in the range 1 to 65,535.
description string: Event description, a string of 1 to 127 characters.
log: Logs the event when it occurs.
log-trap log-trapcommunity: Log and trap events. The system performs both logging
and trap sending when the event occurs. log-trapcommunity indicates the community
name of the network management station that receives trap messages, a string of 1 to
127 characters.
none: Performs no action when the event occurs.
trap trap-community: Trap event. The system sends a trap with the community name
being trap-community when the event occurs. trap-community represents network
management station community to which traps are sent, a string of 1 to 127 characters.
owner text: Owner of the entry, a string of 1 to 127 characters. It is case sensitive and
space is supported.
Description
Use the rmon event command to create an entry in the RMON event table.
Use the undo rmon event command to remove a specified entry from the RMON
event table.
When an event is triggered by its associated alarm in the alarm table, the event group
allows you to log it, send a trap, do both, or do neither at all. This helps control the
generation and notification of events.
Note:
When you create an entry, if the values of the specified event description
(description string), event type (log, trap, logtrap or none), and community name
(trap-community or log-trapcommunity) are identical to those of the existing event
entry, the system considers their configurations the same and the creation fails.
You can create up to 60 alarm entries.
Examples
# Create event 10 in the RMON event table.
<Sysname> system-view
[Sysname] rmon event 10 log owner user1
Chapter 2 RMON Configuration Commands
2-12